测绘学报 ›› 2014, Vol. 43 ›› Issue (7): 698-704.

• 学术论文 • 上一篇    下一篇

相对定向的机载惯性测量装置视准轴误差求解方法

付建红   

  1. 武汉大学遥感信息工程学院
  • 收稿日期:2013-01-23 修回日期:2014-02-10 出版日期:2014-07-20 发布日期:2014-07-29
  • 通讯作者: 付建红 E-mail:fu_jianhong@126.com
  • 基金资助:

    利用像底点检校IMU视准轴误的方法及应用研究

A Solving Method for the Boresight Misalignment of Airborne IMU Based on Relative Orientation

  • Received:2013-01-23 Revised:2014-02-10 Online:2014-07-20 Published:2014-07-29

摘要:

利用航摄像片存在的相对几何位置关系,将机载IMU视准轴误差引入立体像对相对定向模型中,提出了一种基于相对定向的机载IMU视准轴误差求解新方法。详细推导了基于单个立体模型和连续立体模型求解IMU视准轴误差的数学模型,并用三组带有IMU设备获取的实际航空影像数据进行了试验验证。结果表明,所推导的机载IMU视准轴误差求解方法是正确、可行的,利用三张以上相邻像片构成的连续立体模型即可求解出IMU的视准轴误差,避免了野外布设检校场和其他地面控制条件带来的诸多问题,有利于带机载IMU的航空遥感快速对地目标定位。

关键词: 机载IMU, 视准轴误差, 相对定向

Abstract:

The boresight misalignment of airborne Inertial Measure Unite (IMU) is introduced into relative orientation model of aerial stereo image pairs using the inherent relative geometric relationship between aerial images, and a novel method to solve the boresight misalignment of airborne IMU based on relative orientation is proposed. The mathematical models for solving the boresight misalignment of airborne IMU are derived in detail based on a single stereo model and multiple consecutive stereo models, respectively. Then, three sets of actual images obtained with IMU are tested. The empirical results show that the mathematical model established is correct and feasible, and the boresight misalignment could be solved using multiple consecutive stereo models constituted by more than three adjacent aerial images. The method proposed in this paper could avoid many problems brought about by setting calibration field and the other ground control conditions, and it is beneficial for direct and quick georeferencing when using aerial remote sensing equipment with airborne IMU.

Key words: airborne inertial measure unite, boresight misalignment, relative orientation

中图分类号: