测绘学报 ›› 2019, Vol. 48 ›› Issue (2): 161-168.doi: 10.11947/j.AGCS.2019.20170655

• 大地测量学与导航 • 上一篇    下一篇

验潮站和深海压力仪用于卫星高度计性能评估的可行性分析

管斌1,2,3, 孙中苗1,3, 刘晓刚1,3, 翟振和1,3   

  1. 1. 地理信息工程国家重点实验室, 陕西 西安 710054;
    2. 信息工程大学地理空间信息学院, 河南 郑州 450052;
    3. 西安测绘研究所, 陕西 西安 710054
  • 收稿日期:2017-11-27 修回日期:2018-09-06 出版日期:2019-02-20 发布日期:2019-03-02
  • 作者简介:管斌(1988-),男,博士,助理研究员,研究方向为卫星测高和空间地球物理测量。E-mail:pershingb@gmail.com
  • 基金资助:

    国家自然科学基金(41774018;41674082);地理信息工程国家重点实验室自主研究课题(SKLGIE2018-ZZ-4)

Feasibility analysis of performance validation for satellite altimeters using tide gauge and deep-ocean bottom pressure recorder

GUAN Bin1,2,3, SUN Zhongmiao1,3, LIU Xiaogang1,3, ZHAI Zhenhe1,3   

  1. 1. State Key Laboratory of Geo-information Engineering, Xi'an 710054, China;
    2. Institute of Geography Spatial Information, Information Engineering University, Zhengzhou 450052, China;
    3. Xi'an Research Institute of Surveying and Mapping, Xi'an 710054, China
  • Received:2017-11-27 Revised:2018-09-06 Online:2019-02-20 Published:2019-03-02
  • Supported by:

    The National Natural Science Foundation of China (Nos. 41774018;41674082);The Foundation of State Key Laboratory of Geo-information Engineering (No. SKLGIE2018-ZZ-4)

摘要:

在传统卫星高度计定标途径之外,探索了远海孤岛验潮站和深海压力仪分别用于卫星高度计性能评估的可行性。采用Harvest石油平台验潮站、1890000号验潮站和21419号深海压力仪,计算了Jason-3测量海面高偏差以及Jason-2、Jason-3海面高之间的相对偏差。由3种设备得到的Jason-3海面高偏差序列的标准差分别为3.98、2.87、8.61 cm,Jason-2、Jason-3海面高之间的相对偏差(Jason-3-Jason-2)分别为-3.62±2.17、-2.58±1.97、-2.60±1.30 cm,与国外定标站计算结果相比较,结果表明:Jason-3海面高相比于Jason-2海面高低约3.0 cm;选用的深海压力仪适合用于Jason-2、Jason-3之间海面高相对偏差的计算,但不适用于单颗卫星的定标或性能评估;远海孤岛验潮站适用于两者。

关键词: 卫星测高, 高度计定标, 验潮站, 海啸深海评估与预警, 相对偏差, 压力仪

Abstract:

Independent of traditional approach of satellite altimeter calibration, the feasibility of altimeter validation using tide gauge located on solitary island at open sea (TGSI) and deep-ocean bottom pressure recorder (BPR) separately is initially studied. Bias of Jason-3 sea surface height (SSH) and relative SSH bias (△bias) between Jason-2 and Jason-3 is calculated using the data of tide gauge on Harvest oil platform, tide gauge No.1890000 and BPR No.21419. The standard deviations of calculated SSH bias sequence are 3.98 cm, 2.87 cm and 8.61 cm respectively, and △bias (Jason-3-Jason-2) is -3.62±2.17 cm, -2.58±1.97 cm and -2.60±1.30 cm respectively. Comparing to the results reported by foreign calibration sites, the results show that Jason-3 SSH is 3.0 cm lower than that of Jason-2. The selected BPR is appropriate to the calculation of relative SSH bias between Jason-2 and Jason-3, but it is not suitable for calibration or validation of single satellite. TGSI is appropriate to both.

Key words: satellite altimetry, altimeter calibration, tide gauge, deep-ocean assessment and reporting of Tsunamis, relative bias, pressure recorder

中图分类号: