Acta Geodaetica et Cartographica Sinica ›› 2021, Vol. 50 ›› Issue (5): 580-588.doi: 10.11947/j.AGCS.2021.20200415

• Geodesy and Navigation • Previous Articles     Next Articles

Precise absolute and relative orbit determination for distributed InSAR satellite system

SHAO Kai1, ZHANG Houzhe1, QIN Xianping2, HUANG Zhiyong3, YI Bin1, GU Defeng4   

  1. 1. College of Liberal Arts and Sciences, National University of Defense Technology, Changsha 410073, China;
    2. Xi'an Research Institute of Surveying and Mapping, Xi'an 710054, China;
    3. Information Engineering University, Zhengzhou 450001, China;
    4. TianQin Research Center for Gravitational Physics and School of Physics and Astronomy, Sun Yat-sen University (Zhuhai Campus), Zhuhai 519082, China
  • Received:2020-09-01 Revised:2021-02-12 Published:2021-06-03
  • Supported by:
    The National Natural Science Foundation of China (No. 41874028)

Abstract: Precise orbit and baseline determination of formation-flying low Earth orbiters are prerequisites for the success of distributed InSAR satellite system mission. GNSS-based reduced-dynamic absolute and relative orbit determination method is the main method to obtain high-precision orbit and baseline products. The absolute and relative orbit determination for TH-2 satellite system is researched using the space-borne GPS data. The results show that the signal tracking abilities and data qualities of the receivers equipped on satellite A and satellite B are almost the same. By modeling orbital maneuvers with constant empirical accelerations, the influences of orbital maneuvers on absolute and relative orbit determination for TH-2 satellite formation can be effectively eliminated. For single-satellite absolute orbit determination, the three-dimensional (3D) RMS of 6 h overlapping orbit differences is less than 1.2 cm. The RMS values of satellite laser ranging data validation residuals for satellite A and satellite B are 2.76 cm and 2.33 cm, respectively. For dual-satellite relative orbit determination, the 3D RMS of 6 h overlapping baseline differences is about 0.66 mm. Baseline comparison RMS with the products of Xi'an Research Institute of Surveying and Mapping are 0.73 mm, 1.11 mm, 0.51 mm and 1.43 mm in radial, tangential, normal and 3D direction, respectively.

Key words: distributed InSAR, TH-2, absolute orbit determination, relative orbit determination, data quality assessment, GNSS

CLC Number: